Download 728ULT-EI01 : Reference & Installation Manual

8.15
RESTRICT ARMING ON TAMPER TROUBLE
Feature Select Programming D Address 090; Key [5]
Default: Disabled
If this option is enabled, the control panel will not arm the system if the control panel detects a tamper trouble on one or more
zones. The control panel will not arm the system until all tamper trouble conditions are rectified. The trouble can only be cleared
by the installer entering programming mode.
[ENTER] + Installer Code + [10] [9] [10] + [5] ON/OFF+ [ENTER]
This feature will not function if the Tamper Recognition Options (see page 41) are disabled. Only the installer can
clear the Restrict Arming on Tamper Trouble.
ESPRIT 728 ULTRA 37