Download Service Manual - Mechanical Engineering

Specifications
EC Declaration of
Conformity - Low Voltage
Compliance was demonstrated to the following specification as listed in the
Official Journal of the European Communities:
Low Voltage Directive 73/23/EEC, amended by 93/68/EEC.
H
EN 61010-1:2001. Safety requirements for electrical equipment for
measurement control and laboratory use.
H
EN 61010-2-031:2002. Particular requirements for handheld probe assemblies for electrical measurement and test equipment.
U.S. Nationally
Recognized Testing
Laboratory Listing
H
UL 61010B--1:2004, 2nd Edition. Standard for electrical measuring and test
equipment.
H
UL 61010B--2--031:2003. Particular requirements for handheld probe
assemblies for electrical measurement and test equipment.
Canadian Certification
H
CAN/CSA C22.2 No. 61010--1--04. Safety requirements for electrical
equipment for measurement, control, and laboratory use. Part 1.
H
CAN/CSA C22.2 No. 61010--2--031:1994. Particular requirements for
handheld probe assemblies for electrical measurement and test equipment.
H
IEC 61010--1:2001. Safety requirements for electrical equipment for
measurement, control, and laboratory use.
H
IEC 61010--031:2002. Particular requirements for handheld probe assemblies
for electrical measurement and test equipment.
Additional Compliance
Equipment Type
Safety Class
Pollution Degree
Descriptions
Test and measuring equipment.
Class 1 -- grounded product
A measure of the contaminates that could occur in the environment around and
within a product. Typically the internal environment inside a product is
considered to be the same as the external. Products should be used only in the
environment for which they are rated.
H
Pollution Degree 1. No pollution or only dry, nonconductive pollution
occurs. Products in this category are generally encapsulated, hermetically
sealed, or located in clean rooms.
H
Pollution Degree 2. Normally only dry, nonconductive pollution occurs.
Occasionally a temporary conductivity that is caused by condensation must
be expected. This location is a typical office/home environment. Temporary
condensation occurs only when the product is out of service.
TDS1000B and TDS2000B Series Oscilloscope Service Manual
1- 11