Download Yale Operating Instructions

2.
Cable Puller Model LP
Cable Puller Model LP
Yale
Yale
OPERATING INSTRUCTIONS
2.1 CORRECT OPERATION:
Maximum capacity:
• The Yaletrac cable puller was designed to lift, lower and pull loads up to the rated capacity.
The capacity indicated on the hoist is the maximum safe working load which must not be exceeded.
Danger zones:
• Do not lift or transport loads while personnel are in the danger zone.
• Do not allow personnel to pass under a suspended load.
• After lifting or tensioning, a load must not be left unattended for a longer
period of time.
• Start moving the load only after it has been attached correctly and all personnel are clear of the danger zone.
• Welding on hook and wire rope is strictly forbidden. The wire rope must never be used as ground
connection during welding (fig. 5).
• Avoid side pull, i. e. side load on the housing (fig.6). Lift/ pull/ tension only when the wire rope
forms a straight line between both suspension points.
• The wire rope must not be used for lashing purposes. (sling rope) (fig.7).
• Do not knot or shorten the wire rope by using bolts, clamps or other devices (fig.8).
• Do not repair wire ropes installed in the hoist.
• Do not remove the safety catch from the top or bottom hooks.(fig.9).
• Do not throw the hoist down. Always place it properly on the ground.
Safetycatch
Fig. 2
Attaching the load
The operator must ensure that the load is attached in a manner that does not expose himself or
other personnel to danger by the hoist, wire rope or the load.
Temperature range:
The hoists can be operated in ambient temperatures between -10° C and +50° C.
Consult the manufacturer in case of extreme working conditions.
Regulations
The accident prevention act and/or safety regulations of the respective country for using manual
hoists must be strictly adhered to.
Maintenance / Repair:
In order to ensure correct operation not only the operation instructions, but also the conditions for
inspection and maintenance must be complied with. If defects are found stop using the hoist immediately.
2.2 INCORRECT OPERATION:
• Do not exceed the rated capacity of the hoist.
• Do not use the hoist for the transportation of personnel. (fig. 3)
• Do not extend the handle (fig. 4).
Fig. 6
Fig. 7
Fig. 8
Fig. 9
2.3 INITIAL OPERATION:
• Inspection before initial operation
Each hoist must be inspected prior to initial operation by a competent person. The inspection is
visual and functional and shall establish that the hoist is safe and has not been damaged by
incorrect transport or storage. Inspections should be made by a representative of the manufacturer or the supplier although the user company can assign its own suitably trained personnel.
Inspections are instigated by the user.
• Inspection before starting work:
Before starting work inspect the hoist, wire rope and all load bearing constructions for visual defects
every time. Furthermore test, that the load is correctly attached by carrying out a short work cycle of
lifting/pulling or tensioning and releasing.
• Wire rope inspection:
Inspect the wire rope for sufficient lubricant and visually check for external defects, deformations,
kinks, breakage of individual strands, pinching, rust, wear or corrosion damage, overheating and
wear on the wire rope connections.
• Inspection of top and bottom hooks:
Inspect top and bottom hooks for deformations, damage, cracks, wear or corrosion marks.
Fig. 3
4
Fig. 4
Fig. 5
5