Download User manual - Help and support

Twist 654 - CL540 / LUG BE PTT en / A31008-M2602-E151-1-2M19 / starting.fm / 11/19/14
Getting started
Getting started
Checking the contents of the package
u
u
u
u
u
u
u
u
One base station,
One power adapter for the base,
One phone cord with plug,
One handset,
One battery cover (rear cover for the handset),
Two batteries,
One rubber seal for the headset connection,
One user guide.
Setting up the base station
The base is designed for use in closed, dry rooms in a temperature range of +5°C to +45°C.
¤ Set up the base on a level, non-slip surface at a central point in the building or house, or
mount the base on the wall (¢ page 7).
The phone's feet do not usually leave any marks on surfaces. However, due to the multitude of
different varnishes and polishes used on today's furnishings, marks on the surfaces cannot be
completely ruled out.
Notes
u Never expose the telephone to the effects of heat sources, direct sunlight or other
electrical devices.
u Protect your telephone from moisture, dust, corrosive liquids and fumes.
u Pay attention to the range of the base. This is up to 50 m inside buildings and up to 300 m
in unobstructed outdoor areas. The range is reduced when Maximum Range is deactivated (¢ page 31).
Connecting the base station to the telephone network and the
mains power supply
Template Borneo, Version 1, 21.06.2012
¤
3
4
¤
2
1
¤
¤
6
Insert the phone cable into the connection socket 1 at the rear of the
base until it clicks into place and
feed under the cable protection.
Insert the power cable for the power
adapter into the connection socket
2 at the rear of the base and rotate
the right-angle plug under the cable
protection.
Connect the power adapter 3 .
Connect the phone jack using the
phone adapter if necessary 4 .