Download HT-IDE3000 User's Guide

Chapter 12 LCD Simulator
can setup the LCD panel pattern information even if the LCD panel picture file is absent.
Setup the LCD Panel Configuration File
The following two steps are used to setup a panel configuration file:
 Setup the panel configurations, including the segment and common number of the
LCD driver as well as the width and height size of the panel in pixels. Also, the
directory of the panel configuration file and the dot matrix mode can be selected.
 Select the patterns and their positions. This will setup the relationship between the
patterns and the COM/SEG positions.
Setup the Panel Configurations
To setup the panel configurations by selecting the HT-LCDS File menu, New command.
The Panel Configuration dialog box (Fig 12-4) will be displayed. Setup the correct LCD
driver data, COM/SEG number, Width, Height and Directory of the pattern, then press the
[OK] button. After setting up the panel configuration, the system returns to Fig 12-2 for
pattern selection.
Fig 12-4
The panel configurations include:
 The default number of the LCD driver for this microcontroller is displayed when
Fig12-4 is displayed. To ensure that these numbers are the same as the actual setting
number of the LCD driver for the micro controller.
 Width and Height. These are the size of the panel screen in pixels and can be
changed to adjust the panel screen.
 Panel configuration file directory. Select the directory where the panel configuration
134