Download Runner Series User's Guide

LCD KEYPAD
Most of the main actions like ARM, DISARM, arm STAY,
etc… are the same at the crow LCD keypad. But in the
LCD keypad the user can change texts like zone name
and area names, adjust the backlight and buzzer tone.
Adjusting Backlighting and Buzzer Tone
Adjusting the LCD Keypad Backlighting
The user can independently adjust the backlight level of
the LCD display and the Keypad Buttons from off to on
with 16 steps in between. The Buttons used for these
special functions vary depending on the LCD keypad.
To increase the Crow LCD backlight level Press
“CONTROL” followed within 2 seconds by “STAY”. By
holding down the “Control” button and repeatedly
pressing the “STAY (Left Arrow)” button you can
increase the LCD backlight level to the maximum.
To reduce the Crow LCD backlight level Press
“CONTROL” followed within 2 seconds by “BYPASS”. By
holding down the “Control” button and repeatedly
pressing the “BYPASS (Right Arrow)” button you can
decrease the LCD backlight level until it is off.
To increase the Crow Keypad Button backlight
level Press “CONTROL” followed within 2 seconds by
“MEM”. By holding down the “CONTROL” button and
repeatedly pressing the “MEM (Up Arrow)” button you
can increase the Keypad LED backlight level to the
maximum.
To reduce the Crow Keypad Button backlight level
Press “CONTROL” followed within 2 seconds by “ ”. By
holding down the “CONTROL” button and repeatedly
pressing the “(Down Arrow)” button you can decrease
the Keypad LED backlight level until it is off.
25