Download Smart Network Access System User Guide

SMAR TNA ADMINISTRATION
Resetting to factory defaults
Resetting to factory defaults
If necessary, you can reset the Controller module to its factory default settings. Resetting the controller should not be
done lightly as the following settings are affected:
•
Resets IP address to 192.168.254.100
•
Resets login accounts to admin (password admin) and user (password user)
•
Erases 1U Backplane and Controller mappings
To reset to factory defaults:
1
Login to the SmartNA web interface.
2
Click Device Administration .
3
Select the Factory Reset tab.
4
Click Set Defaults .
Figure 32: The factory reset screen
Saving changes to NVR
SmartNA NVR, or non-volatile RAM, stores user names, passwords, port mappings, and port configuration settings.
Any changes you make to these settings must be saved to NVR to make them available after a system restart or reboot.
To save changes to NVR from the web interface:
1
Login to the SmartNA web interface.
2
Click Device Administration .
3
Select the NVR tab.
4
Click Make Permanent .
To save changes to NVR from the command line:
1
From the command line, login to the SmartNA System as an administrator.
2
To save changes to NVR, enter:
save
SmartNA System User Guide
44