Download Operating instructions for dishwashers

Electrical connection
,Please follow the installation
instructions carefully.
All electrical work should be carried
out only by a suitably qualified and
competent person, in strict
accordance with national and local
safety regulations.
Ensure power is not supplied to the
appliance while installation work is
being carried out.
This dishwasher is supplied with a
mains cable and moulded plug ready
for connection to an a.c. single phase
supply, (230 V 50 Hz for NZ and
Australia) via a fused plug and suitable
switched socket which is easily
accessible after installation.
The wires in the mains lead are
coloured in accordance with the
following code:
Green/yellow = earth
Blue
= neutral
Brown
= live
If the colours of the wires in the mains
lead of this appliance do not
correspond with the coloured markings
identifying the terminals of your plug,
proceed as follows:
^ The wire which is coloured green and
yellow must be connected to the
terminal in the plug which is marked
with the letter E or by the earth
symbol z or coloured green, or
green and yellow.
^ The voltage, rated load and fuse
rating are given on the data plate
located above the door. Please
ensure that these match the
household mains supply.
^ The wire which is coloured blue must
be connected to the terminal in the
plug which is marked with the letter N
or coloured black.
For extra safety it is advisable to install
a residual current device (RCD), with a
trip current of 30 mA.
^ The wire which is coloured brown
must be connected to the terminal in
the plug which is marked with the
letter A (AUSTRALIA).
^ Do not connect via an extension lead.
,If the connection cable is
damaged it must be replaced with a
complete connection box and cable
by a Miele approved service
technician only.
WARNING:
THIS APPLIANCE
MUST BE EARTHED
69