Download Installation Manual

Setup – Other Parameters
13.10.2.
Number
1
2
3
4
5
6
5009-33 Installation Manual
Communication Port Settings
Description
The IP Address field presents the Static Internet Protocol address value currently
stored in the Comm IF module (Flash). To change the IP address to match an
existing LAN info structure, type in the desired value and click on the SUBMIT
button. If the parameter change causes desirable operation click on the SAVE
button to store value to Flash. This address must conform to the nnn.nnn.nnn.nnn
format where nnn is a number between 0 and 255.
The Net Mask field presents the Subnet Mask address value currently stored in the
Comm IF module. To change the Subnet to match an existing LAN info structure,
type in the desired value and click on the SUBMIT button. If the parameter change
causes desirable operation click on the SAVE button to store value to Flash. This
address must conform to the nnn.nnn.nnn.nnn format where nnn is a number
between 0 and 255.
The Gateway field presents the Static Gateway Internet Protocol address value
currently stored in the Comm IF module. To change the Gateway IP address to
match an existing LAN info structure, type in the desired value and click on the
SUBMIT button. If the parameter change causes desirable operation click on the
SAVE button to store value to Flash. This address must conform to the
nnn.nnn.nnn.nnn format where nnn is a number between 0 and 255.
The TCP Port 0 field presents the Transmission Control Protocol Port 0 value
currently stored in the Comm IF Module. To change the Port value to match an
existing LAN info structure, type in the desired value and click on the SUBMIT
button. If the parameter change causes desirable operation click on the SAVE
button to store value to Flash. This address must conform to the nnnn format where
nnnn is a number between 0 and 65535.
The TCP Port 1 field presents the Transmission Control Protocol Port 1 value
currently stored in the Comm IF Module. To change the Port value to match an
existing LAN info structure, type in the desired value and click on the SUBMIT
button. If the parameter change causes desirable operation click on the SAVE
button to store value to Flash. This address must conform to the nnnn format where
nnnn is a number between 0 and 65535.
The UDP Port presents the User Datagram Protocol Port value stored in the Comm
IF Module.
This port is specifically used to perform software upgrades to the Comm IF Module
and should NOT be changed.
13-7