1
Download Plasterboard Installation Manual
Transcript
Installation Wet Areas Studs blocked @ 600mm centres Vertical corner flashing angle Boral Wet Area Plasterboard™ Boral Wet Area Taping Cement™ and Reinforcing tape followed by two coats of Boral Wet Area SealCote™ (if required*) prior to tiling. Ceramic wall tiles Flexible sealant relief joint - 6mm Tap body Flexible sealant Relief joint - 6mm Boral Wet Area Sealant™ followed with Boral Wet Area Taping Cement™ and two coats of Boral Wet Area SealCote™ (if required*) prior to tiling Ceramic Wall Tiles Boral Wet Area Plasterboard™ Figure 66 Typical tap penetration Figure 67 Internal corner Boral Wet Area Plasterboard™ Nogging 2mm Boral Wet Area Plasterboard™ Ceramic wall tiles Nogging Skim coat of Boral Wet Area Taping Cement™ at cut edge, followed by two coats Boral Wet Area SealCote™ (if required*) prior to tiling. 2mm 6mm Flexible sealant relief joint - 6mm Stud 5 - 10mm Boral Wet Area Sealant™ 6mm Plate Ceramic wall tiles Skim coat of Boral Wet Area Taping CementTM at cut edge followed by two coats of Boral Wet Area SealCoteTM (if required*) prior to tiling. 5 - 10mm Boral Wet Area SealantTM Flexible sealant relief joint - 6mm Bath edge profile Preformed shower base Figure 68 Bath and wall junction Figure 69 Preformed shower base and wall junction * The application of Boral Wet Area SealCote™ is not required if a waterproofing membrane is applied by a specialist contractor over the whole face of wet area walls. 38 August 2007 Boral Plasterboard Installation Manual
