Download Exsulite Specification & Installation Manual

2.2.4 Over Roof Set Out – Exsulite Angled Starter Piece (SP1)
The Exsulite Angled Starter Piece (SP1) is to be installed horizontally above roof section and fixed to each stud
50mm & 150mm from top edge
NOTE: Ensure fixings do not penetrate into metal flashing and ensure that the flat or pitched roof has had the
correct flashing installed by others which is fit for purpose and is sloping away from the wall cladding
When installing the Exsulite Angled Starter Piece (SP1) channel above a deck, flat or pitched roof, ensure a
gap of is left between the bottom of the Exsulite Angled Starter Piece (SP1) and the finished level.
1
1. Install Exsulite Cavity Spacers
with galvanised clouts on all studs
to top edge of roof flashing.
2
B
A
2. Determine height of Exsulite
Angled Cavity Starter Piece (SP1).
A) Minimum 25mm gap for tiled
roofs and 5-20mm for metal roofs.
B) Building wrap must terminate
20mm above 3mm gap
between panel and roof flashing.
Approximately 3mm gap
between back of panel and metal
roof flashing.
NOTE: Refer to Exsulite Construction Drawings EXS804A, EXS805A, EXS805B, for clarity.
Exsulite Specification & Installation Manual Version 2 · 01 July 2015
27