Download USER MANUAL
Transcript
MINAC Systems USER MANUAL 63860.doc 5.2.3 Revision A 31 January 2005 Change PIN code Menu (menu 27) This menu allows the operator to change the PIN code. First enter the old PIN code and then enter the new PIN code twice: Give old PIN code: Give new PIN code: Retype new PIN code: <0-9999> <0-9999> <0-9999> Return to the previous menu by pressing F9. 5.2.4 Setpoint Menu (menu 3) This menu is used to select the mode of operation (type of regulation). Only one of the first three modes in the list can be activated at a time (mutually exclusive functions). In addition, this menu contains a function for selecting the setpoint source and signal type to/ from the external control. F0 F1 F2 F3 F6 AC Current DC Power Temperature Setpoint source Ext. signal select F7 F8 Ext. setpoint signal type Ext. feedback signal type <ACTIVE/OFF> <ACTIVE/OFF> <ACTIVE/OFF> <LOC/EXT/HHT/DEFAULT> <DC power/AC current/DC voltage/Frequency/Temperature> <0-10V/0-20mA/4-20mA> <0-10V/0-20mA/4-20mA > Return to the Main Menu by pressing F9. Setpoint source The four options given in function F3 "Setpoint source" have the following definitions: LOC EXT HHT DEFAULT Setpoint from the control panel “up” and “down” arrows. Setpoint from an external device. Setpoint from the HHT setpoint control. Setpoint from the source where the power-on command is detected. If HHT handle is not equipped with a power control device make sure not to select HHT as Setpoint source as this will result in zero setpoint value. © For reproduction rights, see cover page. Page 14