Download VGA Broadcaster User Guide
Transcript
Recording 10.5 Starting and Stopping Recording The recorder status is shown in the Web Admin interface. It is located on the left hand side of the screen above the Web Admin interface’s main menu. The ability to manage a recording with the Web Admin interface is done using these buttons. Note that the format of the recorded file is specified clicking the Recorded Files button and selecting the required File Type value. Figure 43 Recorder Status To start a recording, click the Start button in the Recorder status section of the main menu. To stop a recording, click the Stop button in the Recorder status section of the main menu. To close the file being recorded and start recording to a new file, click the Reset button. Or, alternatively click Stop and click the Start button again. It is possible to specify whether the recording is stopped in case there is no signal. To enable this parameter, click the Recorded Files button of the Web admin interface and select the Stop recording in the absence of VGA/DVI and video signals check box. Note that in case both signals are streamed via DVI and video ports, recording will be stopped only if streaming through both ports is interrupted. If either video signal is continued, recording will be continued too. 10.6 Viewing the Current Recording Viewing the broadcast as it is being recorded is performed by doing the following: 66 VGADVI Broadcaster User Guide