Download HSPICE Simulation and Analysis User Guide
Transcript
Chapter 5: Sources and Stimuli Independent Source Functions The time from 0 to the first transition is: tdelay+N*tsample-tr(tf)/2 ■ N is the number of the same bit, from the beginning. ■ If the first transition is rising, this equation uses tr. ■ If the first transition is falling, it uses tf. Example The following example shows a pattern source with two b-strings: *FILE: pattern source gereral form v1 1 0 pat (5 0 0n 1n 1n 5n b1011 r=1 rb=2 b0m1z) r1 1 0 1 In this pattern: ■ High voltage is 5 v ■ Low voltage is 0 v ■ Time delay is 0 n ■ Rise time is 1 n ■ Fall time is 1 n ■ Sample time is 5 n The first b-string is 1011, which repeats once and then repeats from the second bit, which is 0. The second b-string is 0m1z. Since neither R and RB is specified here, they are set to the default value, which is R=0, RB=1. Example The following b-string and its repeat time R and repeating start bit RB cannot use a parameter—it is considered as a undivided unit in HSPICE and can only be defined in a .PAT command. *FILE:pattern source using parameter .param td=40ps tr=20ps tf=80ps tsample=400ps VIN 1 0 PAT (2 0 td tr tf tsample b1010110 r=2) r1 1 0 1 In this pattern: 150 ■ High voltage is 2 V. ■ Low voltage is 0 V. ■ Time delay is 40 ps. HSPICE® Simulation and Analysis User Guide Y-2006.03
Related documents
HSPICE RF User Guide - RFIC Group @ Fudan University
HSPICE RF User Guide - RFIC Group @ Fudan University
Dialogic DSI Signaling Servers SS7G41 Operators Manual
Star-Hspice User Guide
HSPICE user`s manual - Electrical & Computer Engineering
Pompe de surface Guinard
HDL Designer Series User Manual
HSPICE User Guide, RF Analysis
Star-Hspice Quick Reference Guide
CosmosScope Reference Manual
Spectre Circuit Simulator User Guide
Spectre Circuit Simulator User Guide