Download INSTALLATION MANUAL

Remote controller signal code
CAUTION
Change the indoor unit Signal Code, depending on the remote controllers.
(♦... Factory setting)
After turning off the power, wait 10 seconds or more before turning on it again.
Setting Description
The Function Setting does not become active unless the power is turned off then on
again.
♦
Function
Number
A
00
B
Filter Sign
The indoor unit has a sign to inform the user that it is time to clean the filter. Select the
time setting for the filter sign display interval in the table below according to the amount of
dust or debris in the room. If you do not wish the filter sign to be displayed, select the setting value for “No indication”.
(♦... Factory setting)
Setting Description
Function
Number
Standard (400 hours)
11
Short interval (200 hours)
♦
01
External input control
“Operation/Stop” mode or “Forced stop” mode can be elected.
(♦... Factory setting)
Setting Description
♦
Function
Number
Operation/Stop mode
02
Indoor unit fan control for energy saving
Function
Number
Setting Value
00
Standard
Slightly lower control
01
30
Lower control
Warmer control
Enable or disable indoor unit fan control when the outdoor unit is stopped.
(♦... Factory setting)
Setting Description
02
03
Function
Number
No
♦
Yes
Setting record
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be changed as shown in the table below.
Record any changes to the settings in the following table.
(♦... Factory setting)
Function
Number
Setting Value
00
Lower control
01
31
Warmer control
02
03
01
Setting Description
Setting Value
Filter sign
Cooling room temperature correction
Auto restart
Indoor room temperature sensor switching function
Remote controller signal code
External input control
Indoor unit fan control for energy saving
Auto Restart
Enable or disable automatic system restart after a power outage.
(♦... Factory setting)
Setting Description
♦
00
49
Heating room temperature correction
Standard
Slightly warmer control
Setting Value
*If setting value is “00”:
When the outdoor unit is stopped, the indoor unit fan operates following the setting on the
remote controller continuously.
*If setting value is “01”:
When the outdoor unit is stopped, the indoor unit fan operates at very low speed intermittently.
Heating Room Temperature Correction
♦
01
46
Forced stop mode
(♦... Factory setting)
Setting Description
Setting Value
00
(Setting forbidden)
03
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be selected as shown in the table below.
♦
03
Setting Value
Cooling Room Temperature Correction
Setting Description
02
D
02
No indication
01
44
C
00
Long interval (1,000 hours)
Setting Value
Function
Number
Yes
40
No
After completing the FUNCTION SETTING, be sure to turn off the power and turn it on
again.
Setting Value
00
01
* Auto restart is an emergency function such as for power failure etc. Do not start and stop
the indoor unit by this function in normal operation. Be sure to operate by the control unit,
or external input device.
15.CUSTOMER GUIDANCE
Explain the following to the customer in accordance with the operating manual:
(1) Starting and stopping method, operation switching, temperature adjustment, timer, air
flow switching, and other remote control unit operations.
(2) Air filter removal and cleaning, and how to use the air louvers.
(3) Give the operating manual to the customer.
Indoor room temperature sensor switching function
(Only for Wired remote controller)
The following settings are needed when using the Wired remote controller temperature
sensor.
(♦... Factory setting)
Setting Description
♦
No
Yes
Function
Number
42
Setting Value
00
01
* If setting value is “00” :
Room temperature is controlled by the indoor unit temperature sensor.
* If setting value is “01” :
Room temperature is controlled by either indoor unit temperature sensor or remote controller unit sensor.
En-10
9333005003-04_IM.indb 10
2013-3-6 14:52:48