Download User Manual

Chrome User Manual | Procedure 3
Procedure 3
This Procedure includes the following:
Removing rear wheels and attaching them to and from your wheelchair.
The wheels can, therefore, be installed or removed without using tools.
Removing rear wheels and attaching them to
and from your wheelchair.
1. Push in the detent/RGK button of the quickrelease axle. Pull both axle and wheel away
from your wheelchair. See figure 17.
2. Repeat STEP 1 for the opposite wheel
3. To reinstall the rear wheels onto your
wheelchair. Push in the detent/RGK button
of the quick-release axle and insert quick
release axle into the camber bar. Pushing
both axle and wheel towards your wheelchair
WARNING
Changing the size of your rear wheels can
affect the performance of the wheelchair. Please
contact RGK Wheelchairs Ltd,
numbers located on the back of this manual before
changing rear wheel size.
NOTE
Pull on the rear wheels to make sure the detent
pin / RGK cap of the quick release axle are fully
released before operating the wheelchair.
Fig 17
WARNING
Any adjustments to your quick release pins –
then YOU must ensure your wheels lock on both
sides of your wheelchair.
When attaching the rear wheels, always check
that they are securely mounted. Pull on the rear
wheels to make sure the detent pin/RGK cap of
the quick release axle are fully released before
operating the wheelchair.
You should NOT be able to pull the rear
wheel off.
Chrome User Manual
Issue No: 12 | 2014
Need replacement parts? www.rgklife.com
21