1
Download Operators Manual - Keison Products
Transcript
6.8 CO Alarm It is possible to set a point in the range of the sensor so that it alarms and warns the user of a dangerous level of Carbon Monoxide. The default level is set at 400 ppm. This should be used when there is a local limit on the level of CO that should not be emitted from a boiler. TO SET THE CO ALARM LEVEL Press the -- -- -- -- -- -- -- -- -- -- -- -- -- SET/CAL SET -- -- -- -- -- -- -- -- -- -- -- -- -Pressing the key displays SET CO ALARM 0400 CO Set each number as detailed in Setting Time When the CO level rises above the set value the following screen will be displayed every ten seconds. This will continue until the CO level falls below the alarm setting. -- -- -- -- -- -- -- -- -- -- -- -- -CO ALARM 410 ppm -- -- -- -- -- -- -- -- -- -- -- -- -- KM9106 Operators Manual Keison Products www.keison.co.uk [email protected] Tel: +44 (0)1245 600560 29 Fax: +44 (0)1245 600030
