Download VPOP3 User Guide - Paul Smith Computer Services

Transcript
VPOP3 – Your email post office
Pegasus Mail
Pegasus mail is a very flexible program, hence this description will only handle a
certain (common) case. This assumes that you are using the 32 bit Pegasus
software, which has been installed on a TCP/IP network, and you are using the
WinSock built into Pegasus, rather than going through a User-Defined Gateway
(UDG).
From the menu, choose File—Network Configuration.
For Receiving Mail
POP3 host Enter the IP address of the VPOP3 server (or 127.0.0.1 if you are not on a
LAN).
User nameEnter the Username defined in VPOP3 for the mailbox you want to
access.
Password Enter the Password defined in VPOP3 for the mailbox you want to
access.
For Sending Mail
SMTP host
Type the IP address of the VPOP3 server (the same as the POP3 host defined
above)
Page 136
User Manual
v 1.3.0 May 1999