Download Optidrive HVAC User Guide

Optidrive ODV-2 User Guide Revision 1.11
Optidrive HVAC Start Up Guide
OPTIDRIVE HVAC (IP66 Enclosure).
Mechanical Mounting
Information can be found on page 8,
section 3.5.
HVAC Display
(Status, Diagnostics, and Programming)
Applies to Switched version only
In-built Isolator:
Mains Power On / Off
Keypad Operation can be found in
section 5.5
Hardware Enable Circuit
Link the terminals as shown, optionally
through switch contacts to enable drive
operation.
Control Terminal
Configuration based on factory settings
Fuses or MCB
Check Drive
Rating info in
section 13.4.
Run / Stop
10K Pot
Close the switch to run (enable)
Open the switch to stop
Motor Cable Sizes
Check the rating information in
section 13.4.
PE
L1 L2 L3
AC Supply Connection
200 – 240 Volts + / - 10%: 1 / 3 Phase
380 – 380 Volts + / - 10%: 3 Phase
Motor Connections
Check for Star or Delta connection
according to the motor voltage rating in
section 4.5.
Check Drive Input Voltage information
in section 13.2
Motor Nameplate Details
Motor Rated Voltage: P1-07
Motor Rated Current: P1-08
Motor Rated Frequency: P1-09
Motor Rated Speed (Optional): P1-10
www.invertek.co.uk
3