Download Volume Manager Troubleshooting Guide

Transcript
Failures on RAID-5 Volumes
Note Following severe hardware failure of several disks or other related subsystems
underlying a RAID-5 plex, it may be impossible to recover the volume using the
methods described in this chapter. In this case, remove the volume, recreate it on
hardware that is functioning correctly, and restore the contents of the volume from a
backup.
Parity Resynchronization
In most cases, a RAID-5 array does not have stale parity. Stale parity only occurs after all
RAID-5 log plexes for the RAID-5 volume have failed, and then only if there is a system
failure. Even if a RAID-5 volume has stale parity, it is usually repaired as part of the
volume start process.
If a volume without valid RAID-5 logs is started and the process is killed before the
volume is resynchronized, the result is an active volume with stale parity. For an example
of the output of the vxprint -ht command, see the following example for a stale RAID-5
volume:
V NAME
RVG/VSET/COKSTATESTATE LENGTH
PL NAME
VOLUME KSTATE STATE
LENGTH
SD NAME
PLEX
DISK
DISKOFFSLENGTH
SV NAME
PLEX
VOLNAME NVOLLAYRLENGTH
...
v r5vol
ENABLED NEEDSYNC204800
pl r5vol-01 r5vol
ENABLED ACTIVE 204800
sd disk01-01 r5vol-01disk01 0
102400
sd disk02-01 r5vol-01disk02 0
102400
sd disk03-01 r5vol-01disk03 0
102400
...
READPOL PREFPLEX
LAYOUT
NCOL/WID
[COL/]OFF DEVICE
[COL/]OFF AM/NM
UTYPE
MODE
MODE
MODE
RAID
RAID
0/0
1/0
2/0
raid5
RW
ENA
dS
ENA
3/16
c2t9d0
c2t10d0
c2t11d0
This output lists the volume state as NEEDSYNC, indicating that the parity needs to be
resynchronized. The state could also have been SYNC, indicating that a synchronization
was attempted at start time and that a synchronization process should be doing the
synchronization. If no such process exists or if the volume is in the NEEDSYNC state, a
synchronization can be manually started by using the resync keyword for the vxvol
command. For example, to resynchronize the RAID-5 volume in the figure “Invalid
RAID-5 Volume” on page 16, use the following command:
# vxvol -g mydg resync r5vol
Chapter 1, Recovery from Hardware Failure
13