Download Operating instructions Universal Lathes

Transcript
1.
Technical Data
1.2
Universal Lathe D2400 E
Working range
Centre distance .............................................................
Centre height.................................................................
Work spindle
Main drive......................................................................
Power ............................................................................
Spindle speed infinetely variable...................................
Spindle bore ..................................................................
Taper in spindle nose.................................................
Cross table
diameter of chuck work above cross slide rest .............
cross table range of displacement ................................
turning carriage´s range of displacement......................
swivel-feature of the upper slide rest ............................
Height of turning tools max. ..........................................
Guideways
Longitudinal support......................................................
Cross support ................................................................
Stripping rings ...............................................................
Length of guides............................................................
Width of guides..............................................................
Ø of guides ....................................................................
diameter of chuck work, measured above the guiding
bars ...............................................................................
Tailstock
Tail spindle´s range of displacement ............................
Tail spindle´s hole bore .................................................
lateral displacement of the tailstock to both sides ........
Advance
Automatic feed ..............................................................
Screw-cutting attachment Optional
- metric thread ...........................................................
- inch thread ..............................................................
Noise values according DIN 45635 - part 1
Emission data:
no-load running
load running
500 mm
110 mm
electronic adjustable motor
1,4 Kw, 230V, 50 Hz
30 – 2300 r.p.m.
20 mm optional 30 mm
MT3 – only for spindle bore 20 mm
126 mm
110 mm
58 mm
360°
20 mm
ground guiding bars
adjustable dovetail guide
protection of the guides
740 mm
130 mm
30 mm
220 mm
65 mm
cone2
±10 mm
0,085 mm/r.p.m. Optional 0,16
0,4 - 4,0 mm
10 - 32 thread per inch (TPI)
LpA = 63 dB(A)
LpA = 67 dB(A)
- Subject to technical alterations -
7