Download future:speed controller for brushless and

Transcript
9.3.1.4 Operational modes
(future-18be/ -20Le/ -25be from version 6; -be/ -bo/ -Ko from version 14)
Mode 1: Standard-mode (single beep e)
- Maximum efficiency at highest power and rotational speed.
Mode 2: Timing retarded (double tone beep ee).
- use when having problems with runtime and/or too much current with Aveox, Lehner and Hacker motors (RPM/volt tables of
these manufacturers fits better with this mode).
- Maximum of motor-efficiency changed to lower currents.
9.3.1.5 Mode conversion
The conversion must be done with the prog-adapt-2/3 cable
(optional, not delivered with the future).
Alternatively mode can be changed by making a short circuit on the plug/
socket of the receiver cable between the pulse lead (orange, yellow or
white) with the 5V-BEC-voltage (red lead). In that case do not connect
receiver cable to the receiver.
a
Disconnect flight battery.
b
Connect prog-adapt-2/3 cable between receiver cable (attached to
the future) and receiver.
c
At first switch receiver on.
d
Then connect flight battery and wait about 3 seconds, then ...
e
The motor beeps 1* with old mode beep. Within 1 second after beep ...
f
Disconnect prog-adapt-2/3 cable from future receivcer cable.
g
The motor beeps 1* with old mode beep. Within 2 seconds after beep ...
h
Connect prog-adapt-2/3 cable to the future receiver cable again.
i
The motor now beeps continuously with the new mode beep tone.
j
Disconnect and remove prog-adapt-2/3 cable.
k
Disconnect flight battery.
- 15 -