Download User Manual - Samsung Techwin UK

4. If you inevitably use the “Spacer” because of the door structure,
ensure that you fix it to the door using proper-length screws.
Installation (SIM-0002)
To install the sensor and magnet housings
1. Remove the cover from each housing as shown.
2. Drill a hole and use the screws to fix the housing.
(for wooden materials, use screws only)
 Drill a 2.5mm hole and use the 3mm screws.
You can use screws in sizes of up to 4mm for this purpose.
• Wiring
One-strand: 0.65mm ~ 0.9mm, Multi-strand: 0.5mm ~ 0.75mm
• Use the manual screwdriver when tightening the screws.
• The maximum allowable torque for clamping is 10kgf/cm2.
3. Connect the cables as necessary.
 Use the manual screwdriver when connecting the cables.
4. Close the cover.
5. Repeat the same procedure above for the magnet housing.
English _6