Download Quick SC Installation manual

1 - Preparing Connector
2 - Setting Connector
3 - Install boot onto fiber as shown
A
4 - Removing 0.9 Wire Coating
A
Grip
Pull
Be sure to wear Safety Glasses
B
Open the lock lever
5 - Cleaning Bare Fiber
2 - Set circular groove of connector
tightly onto semicircular ridge “U”
shaped shelf of Jig.
Make sure there is no space between the
wedge and the connector, if there is, realign the products before proceeding.
4 A - Remove 0.25 mm or 0.9 mm fiber
jacket remover. coating, using
appropriate fiber jacket remover.
6 - Screening Fiber
7 - Setting Fiber on the Fiber Holder
30o
degree
X
6 - Bend fiber several times by moving it
with your finger back and fourth.
IF FIBER BRAKES, START WITH A
NEW FIBER FROM THE BEGINNING.
8 - The Fiber Cleaver
D
B
C
left
right
down
7B - When fully pushed forward guide
member should not be visible from the
back end of the fiber holder
B
IF OUT OF TOLERANCE,
REWORK FROM
PROCEDURE(4)!
SET THE FIBER HOLDER TIGHTLY!
11 - Remove the Wedge
12 - Open the Front and Back Cover
PULL OUT WEDGE AND OPEN COVER.
15 - Completion
CLICK!
<2mm
LENGTH OF 0.9 BUFFER IS WITHIN 2 MM !
D
1
2
3
X
7D - SET THE FIBER ALONG THE GROOVE
TIGHTLY BEFORE CLOSING THE BACK COVER.
10A - Set the fiber holder to the guiding rail
10 B - Slide holder slowly until it is stopped.
BE CAREFUL NOT TO HIT THE EDGE OF FIBER!
10C - See diagram
10D - CHECKING WHETHER THE FIBER IS
BENDING OR NOT (IMPORTANT)!
Push the arm to remove the wedge
m
C Close the front cover
GUIDE MEMBER MUST BE PUSHED AS
FAR FORWARD AS POSSIBLE.
Close the cover in the order of above
10 - Inserting Fiber
A
Guiding Rail
C 1. Open the middle cover
CLICK!
2. Insert until sounding click
Length of bare fiber: 9~11 mm
8 - A - Insert slider
B - Set the fiber holder to the Cleaver
C - Set the fiber holder tightly
D - Push the cover of the Cleaver
ly 30 m
up
9 - Checking Cut Dimension
A
Appro
ximate
4 B - Removing appropriate length of
the fiber jacket
A
Clean bare fiber with a lintfree Gauze Pad moistened
with pure Alcohol
5 - DO NO T USE DIRTY GAUZE!
B
B
13 - Take out Connector
D Small amount of bending is normal
14 - Fitting Boot