Download User Manual - Electrovision
Transcript
Vasto DJ Lighting Effect G017A User Manual INTRODUCTION Thank you for purchasing the Vasto DJ Lighting Effect. This model is a disco light which uses light beams to produce beautiful designs, and is suitable for small and medium-sized entertainment venues. TECHNICAL DATA Name: Type: Lamp: Voltage: Color: Weight: Measurement: Vasto SRL-473 64610 12/50 W AC 230 V~ 50 Hz RED, YELLOW, BLUE, GREEN, ORANGE 2 kg L250xW141xH120 mm FEATURES • The Classic Twister Light Effect with 3 settings: o Constant Rotation: Gentle-paced clockwise movement for mood setting o Static: Illuminate an event or a point of interest o Sound2Light: Clockwise and anti-clockwise movement in time to the beat of the music • Accessible Lamp Holder for ease of replacement • Sharp/Intense Colour Beams • One single Vasto can light up an average-sized Lounge or other room for house parties and small venues – ideal for children’s parties • The length of throw from the light and sharpness of the pattern travels over a long room – ideal as supplementary lighting effect for mobile DJs User Manual Ver.2 June 2012 (473) Page 2 OPERATING INSTRUCTIONS 1. Unpack the carton to check if there is any damaged or missing parts when you receive the unit, contact your supplier in the first instance if there are any issues with the product. 2. Open the lid to install the lamp. Do not touch the lamp with your hand; we suggest you use a cloth to hold the lamp. Disconnect the unit from the power while changing the lamp. 3. Use a clamp to hang the unit onto the truss and fasten tight. Attach the unit carefully onto the truss by winding a chain through the bracket of the unit. 4. Place the unit where there is adequate ventilation, away from any flammable and explosive objects. 5. Check that the rated power corresponds to the mains supply. BULB INSTALLATION/REPLACEMENT 1. Before opening unit, make sure that the unit is cool and is not connected to any power source. 2. Remove the thumbscrew located at the top/front of the unit. 3. Lift the bulb access door open. 4. Install/replace halogen bulb. Make sure the bulb is in securely; do not touch the glass on the bulb with your bare hands, if you touch the glass, clean it with alcohol using a cotton ball or soft cloth. 5. Close the access doors and tighten the screws. CAUTION • Never open this unit when it is hot and/or is connected to a power source. • For optimal unit performance and longer unit life, you must cycle the use of the unit by giving the unit a 5 minute break to cool down after 15 minutes of continuous use. • Never use this unit in a wet and/or dusty room. • Replace bulbs and fuse with those of proper specifications. User Manual Ver.2 June 2012 (473) Page 3 Electrovision Ltd, Lancots Lane, Sutton Oak, St Helens, WA9 3EX Tel: 01744 745 000 | Tel: 01744 745 001 | Web: www.electrovision.co.uk User Manual Ver.2 June 2012 (473) Page 4