Download Title: Petards Universal Protocol User Manual

Transcript

USER MANUAL
JLUM 5897 Iss. 02
8. CAMERA COMMANDS
Camera setting commands do not return replies. Also note that commands will only
be effective if the associated camera incorporates the selected feature.
ZTx
ZWx
ZST
Zxx
ZD1
ZD0
Start zoom tele where ‘x’ is a speed value between 0 to 7
Start zoom wide where ‘x’ is a speed value between 0 to 7
Stop zoom
Optical zoom direct where ‘x’ is a decimal value between 00 to 18
Digital zoom on
Digital zoom off
FNx
FST
Fxx
FA1
FA0
Start manual focus near (when auto focus off) where ‘x’ is a speed
value between 0 to 7
Start manual focus far (when auto focus off) where ‘x’ is a speed value
between 0 to 7
Stop focus
Focus direct where ‘x’ is a decimal value between 00 to 99
Auto focus on
Auto focus off (manual)
AEA
AEM
AES
AEI
Exposure mode fully automatic
Exposure mode manual
Exposure mode shutter priority
Exposure mode iris priority
APx
APX
SPx
Aperture gain where ‘x’ is an ASCII HEX value between 0 to F.
Aperture gain reset
Shutter speed (when in manual or shutter priority) where ‘x’ is an ASCII
HEX value between 0 to F – see shutter table
Iris aperture (when in manual or iris priority) where ‘x’ is an ASCII HEX
value between 0 to F – see iris table
Gain (when in manual only) where ‘x’ is an ASCII HEX value between 0
to F – see gain table
FFx
IPx
GPx
BL1
BL0
BDx
Backlight compensation on
Backlight compensation off
Backlight compensation level where ‘x’ is an ASCII HEX value between
0 to F – see backlight compensation table
SS1
SS0
Slow shutter (integration) auto
Slow shutter (integration) manual
XM1
XM0
XA1
XA0
IR cut filter out (when in manual IR) for high sensitivity mono
IR cut filter in (when in manual IR) for normal sensitivity colour
IR cut filter operation fully automatic
IR cut filter operation manual
Note: The above commands are only effective for modules with
switched IR cut filter.
Page 5 of 14