Download PH3000 User Manual

A Pop up will show the steps involved in
communicating with the Sensor
 Attempting Wake Up
 Attempting to Connect
 Reading Details
 etc
This will take approx 30 seconds.
If connection cannot be established – check
all power and communication connections.
When connection is established the Monitor
Screen will appear...
This screen updates every 10 seconds and
shows the real time data.
Clock times, Battery Volts, Logging Schedules
Memory Usage should be noted. The Green or
Red Leds indicate if Sensor is actively Logging
or Not.
There are 2 tabs at the bottom.
Hit the Logger Control Tab for all configuration
and Logger set up details.
The Logger Control Screen provides
access to all configuration, Data retrieval,
Logger management and Calibration
routines.
The Logger is very flexible and care must
be taken to check that Data Logging has
been initiated and is working properly, prior
to deploying the sensor into a remote site.
It is recommended that thorough testing of
the sensor be performed in the office to
provide confidence and experience with the
various logger functions.
All Sensors are supplied from the factory
fully calibrated and tested. It is not
normally required to perform any additional
calibration functions on the sensor.
Tyco Environmental Systems
PH3000 User Manual 010-UM-700-5400
Page 22 of 46
© Copyright by Tyco International Ltd. Greenspan Analytical Pty Ltd reserves the right to change product designs and specifications without notice.