Download User manual

MSSpro user manual
latitude and longitude sensor must contain data in decimal degrees. South and West is indicated by negative
values. The file header will not be modified.
Input parameters:
•
Input file name (*.tob file)
•
Output file name (*.tob file)
•
Name of the latitude sensor
•
Name of the longitude sensor
•
Name of the new distance sensor
Output:
The output file contains all channels of the input file and a new distance sensor (unit [m]). The original
values of the other channels remain unchanged.
5.1.10
Dist_wet
Procedure:
The module Dist_wet calculates the distance along the probe track through water. The velocity sensor must
contain the velocity through water in [m s-1]. If a time sensor is given the time values must be given in [s].
Instead of a time sensor a time difference [ms] between the data lines can be specified.
The file header will not be modified.
Input parameters:
•
Input file name (*.tob file)
•
Output file name (*.tob file)
•
Name of the velocity sensor
•
Type of time estimation (existing time sensor or calculation from time difference)
•
Name of time sensor sensor
•
Time step between data lines in [ms]
•
Name of the new distance sensor
Output:
The output file contains all channels of the input file and a new distance sensor (unit [m]). The original
values of the other channels remain unchanged.
5.1.11
Exp_10
Procedure:
The module Exp_10 calculates the inverse logarithm (base 10) of one or more selected channels. The file
header will not be modified.
Input parameters:
•
Input file name (*.tob file)
•
Output file name (*.tob file)
•
Names of selected channels for calculation
Output:
The output file contains all channels of the input file. The original values of the selected channels will be
replaced.
© ISW Wassermesstechnik
Page 21