Download User Manual

Section 3 - Configuration
IPv6
The DAP-1665 can be configured to operate using the IPv6 protocol. If you are connecting the access point to a network which
is using IPv6, you should adjust the appropriate settings in this section.
My IPv6 Select Link-Local Only from the drop-down menu. This will set
Connection is: the access point’s local IPv6 address.
LAN IPv6 Link- The router’s local IPv6 address will be displayed here. This
Local Address: address should be used to access the web-based configuration
utility through the IPv6 protocol.
Click Save Settings at the top of the page to save the current
configuration.
My IPv6 Select Static IPv6 from the drop-down menu. This will allow
Connection is: you to assign a static IPv6 address to the access point.
LAN IPv6 The router’s local IPv6 address will be displayed here. This
Address: address should be used to access the web-based configuration
utility through the IPv6 protocol.
Subnet Prefix Enter the prefix length for IPv6 IP addresses on your network.
Length:
Default Gateway: Enter the default IPv6 gateway address for your network.
Primary DNS Enter the primary IPv6 DNS server address for your network.
Server:
Secondary DNS Enter the secondary IPv6 DNS server address for your network.
Server:
Click Save Settings at the top of the page to save the current
configuration.
D-Link DAP-1665 User Manual
47