Download JMatPro User's Guide

Please read the notes on the selection of which physical properties calculation to use
first.
Input:
•
•
•
Input the heat treatment temperature, the upper limit temperature and a step
size. From room temperature to the heat treatment temperature the phase
distribution in the alloy will taken as that formed at the heat treatment
temperature. Above the heat treatment temperature the phases are taken to be
those in equilibrium.
By default all available phases will be included in the calculation, should you
want to suspend any phases uncheck the Take all phases into account check
box and a phase selection dialog will appear.
The Start Calculation button will launch the calculation.
2.7.4. Dynamic physical properties calculation
Note:
48