Download TMS320C54x C Source Debugger User's Guide

Alphabetical Summary of Debugger Messages
B
Breakpoint already exists at address
Description
During single-step execution, the debugger attempted to set
a breakpoint where one already existed. (This is not necessarily a breakpoint that you set—it may have been an internal
breakpoint that the debugger set for single-stepping).
Action
None should be required; you may want to reset the program
entry point (Debug→Restart) and reenter the single-step
command.
Breakpoint table full
Description
200 breakpoints are already set, and there was an attempt to
set another. The maximum limit of 200 breakpoints includes
internal breakpoints that the debugger may set for
single-stepping. Under normal conditions, this should not be
a problem; it is rarely necessary to set this many breakpoints.
Action
Open the Breakpoint Control dialog box by selecting
Breakpoints from the Configure menu. Delete individual software breakpoints.
C
Cannot allocate host memory
Description
This is a fatal error—it means that the debugger is running out
of memory.
Action
You can invoke the debugger with the –v option so that fewer
symbols may be loaded, or you can relink your program and
link in fewer modules at a time.
Cannot allocate system memory
Description
This is a fatal error—it means that the debugger is running out
of memory.
Action
You can invoke the debugger with the –v option so that fewer
symbols may be loaded, or you can relink your program and
link in fewer modules at a time.
Debugger Messages
D-3