Download Installation manual

MANDO Adapt T211/T212. Disassembly, subsequent storage, and disposal
english
7.2 Disassembling MANDO Adapt T211
WARNING!
Danger of injury due to vertical hanging spindle!
Bending into the machine work area when
disassembling overhead can cause severe head
injuries.
„ Secure components prior to overhead
disassembly.
„ For disassembly on a vertically hanging spindle
always use a suitable mounting aid.
„
Special tools required:
„ Allen wrench AF4
„ Jaw wrench AF13
1.
Put the machine tool in set up mode.
2.
Loosen three screws [Fig. 39/3] on the work piece
specific base end-stop [Fig. 39/1] with the Allen wrench
[Fig. 39/2].
3.
Unlock the work piece specific base end-stop [Fig.
40/1] by turning it counter-clockwise and take it off.
Fig. 39
Fig. 40
Order Hotline +49 [0]7144. 907-333
47