Transcript
VT-MDS Installation Manual VT-ENG-MDS-V1-2412 4 Cameras Switcher for VT05 system VT-MDS switcher is used in VT05 Single Entry Video Doorphone system, for the purpose of CN101 JS/VP JS-OS1 JS/AP JS-OS2 extending 2~4 Cameras. If multi monitors are installed, the JP-VD jumper must be set correctly If 680/686/684/687 monitors are involved, connecting terminals in 210W Board on bracket z z SET Switch Monitor Wiring JW/VP Red IN USE z SET switch to select quantity of extended Cameras z IN USE led indicates working state z 86*86mm standard Installation Box z Suitable for Color or B&W, CCIR or EIA monitors * When CCTV camera is used, connecting 3Y with VIDEO signal, and 2W with GND No extra power supply needed Black Connecting 2~4 Cameras (Outdoor stations or CCTV Cameras) z VT-MDS Wiring Drawing White z Yellow Features: Parts List: VT-MDS part z 5 pcs C3-4P Wiring Cable, colors in RED, WHITE, YELLOW, BLACK Red z White Install the 86 Bottom Box on the wall, or using a existing bottom Box z Wire the cables, and test the single entry system. z Mount the Front Panel with the Installed Bottom Box. Specifications: z Power Supply: DC 10~12V (Powered by Monitors) z Video Switcher: 6dB Gain, 0~6MHz, 75Ohm Impedance z Audio Switcher: Relay contact, < 0.2Ohm z Shielded cable RVVP4*0.3mm2 is needed when less than 30m distance from monitor to camera; Co-axial Cable should be used to connect 3Y and 2W if over 30m distance. Black z Yellow Mount Instruction: Note: z Camera Wiring DS1,2,3,4 From Bottom Side The SET switch must be set to the position according to the Cameras Numbers VT-MDS 4 Cameras Switcher
