Download 3980 Programming System User Manual

5 Translation Formats
Introduction
When a data file (which contains information to be programmed into a device)
is created, it is stored in a specific data translation format. When the data file
is transferred to a programmer, it must be set to handle the appropriate
translation format. During download, the programmer translates the formatted
data and stores it in user memory as a binary image file.
The following translation formats are described in this chapter.
Format
Code
ASCII-BNPF
ASCII-BHLF
01 (05*)
02 (06*)
Texas Instruments SDSMAC (320
5-level BNPF
Formatted Binary
DEC Binary
Spectrum
POF
Absolute Binary
LOF
ASCII - Octal Space
ASCII - Octal Percent
ASCII - Octal
Apostrophe
ASCII - Octal SMS
ASCII - Hex Space
ASCII - Hex Percent
ASCII - Hex Apostrophe
ASCII - Hex SMS
ASCII - Hex Comma
RCA Cosmac
Fairchild Fairbug
MOS Technology
Motorola EXORcisor
Intel Intellec 8/MDS
Signetics Absolut Object
Tektronix Hexadecimal
Motorola EXORmax
Intel MCS-86 Hex Object
Hewlett-Packard 64000 Absolute
Texas Instruments SDSMAC
JEDEC Format (Full)
JEDEC Format (Kernel)
Tektronix Hexadecimal Extended
Motorola 32 bit (S3 Record)
Hewlett-Packard UNIX Format
Intel OMF 386
Intel OMF 286
Intel Hex-32
04
08
10
11
12
14
16
17
30
31
ASCII-B10F
03 (07*)
(09*)
(13*)
(35*)
(36*)
32
37
50 (55*)
51 (56*)
52
57
53 (58*)
70
80
81
82
83
85
86
87
88
89
90
91
92
94
95
96
97
98
99
Page
5-3
5-3
5-3
5-4
5-5
5-6
5-7
5-8
5-9
5-11
5-12
5-14
5-14
5-14
5-14
5-14
5-14
5-14
5-14
5-14
5-14
5-16
5-17
5-18
5-19
5-20
5-20
5-21
5-22
5-23
5-25
5-26
5-27 and 5-30
5-27 and 5-37
5-37
5-39
5-40
5-41
5-42
5-44
* This alternate code is used to transfer data without the STX start code and the ETX end code.
** This alternate code is used to transfer data using the SOH start code instead of the usual STX.
3980xpi/3980/3900/2900 User Manual
5-1