Download Operators Manual

6-5
Replacing the RAYS PCB
1.
Remove 3off upper security screws (M5x15) and slacken 2off lower security
screws (M5x15) and remove the Cover Plate.
Coin Tower Assy (rear side)
RAYS PC board
(inside)
Security screw (M5x15)
Cover Plate
Security screw (M5 x15)
2.
Disconnect the connectors from the RAYS PCB.
Pozi head screws
(with flat and spring washers) (M3 x 8)
Connectors
RAYS PC board
Pozi head screws
(with flat and spring washers) (M3 x 8)
3.
Remove 4off pozi head screws (M3x8), with flat and spring washers, and remove
the RAYS PCB.
4.
Reassemble in reverse order.
Page 66