Download User Manual

Programming Manager
urations are supported by the software. Entering a new name allows to create a new
configuration. The current configuration may be saved using a new name, too.
• Edit Configuration
In this window you can generate the desired hardware configuration for your own
program. In the top left corner of the window the PC is displayed. Double-clicking it
with the left mouse button allows to select an I/O port (COM1 or COM2) and a baud
rate (usually 9600, 2400 for modem operation). Selecting “Devices”, you choose
your hardware and put it into the window pressing the right mouse button. Doubleclicking a specific hardware allows to select cycle time and address. The default
cycle time is set to 100ms. Selecting a wrong cycle time does not affect the functionality of your software, but selecting time masks in the function configurations will
then show wrong entries. In any way the fastest time mask will be the same as the
cycle time of the hardware. The selected address of the master device (S5701,
S5703, S5610 or S67001) has to be 1, the addresses of token bus modules may be
any value greater than 5 and must be the same as selected at the dip-switches of the
corresponding hardware. Extension modules which are connected to other devices
using the serial extension bus must be addressed following the address of the device
to which they are connected. After saving this configuration and exiting the configuration editor, this configuration is available for your program files. The program editor needs this configuration to be aware of available in- and outputs.
• PC Configuration
This is a quick way to select port and baud rate of the PC. Use it if you developed
the program on another PC and now want to send it to S5701 which is not connected
to the same port as it has been at the development PC.
• S83010 Configuration
As a user interface to S5701, the SEAL industrial terminal S83010 may be used.
The graphic LCD display may be configured freely and then down-loaded to the display. This software is described in “Programming of S83010” on page 4-2.
3.3.3 Program
• Select
A standard file selection menu allows to select a program file for each segment.
Entering a new name allows to create a new program. The program editor allows to
save the current program using a new name. At least one segment must be defined.
• Delete Segment
You may delete a segment from the list. The appropriate program file will not be
deleted from the disc. To change the selected program, it is not necessary to delete it
previously.
• Run Conditions
For the program as well as for any segment the run conditions may be selected independently. Be aware that a segment will only run when both the run condition of the
program and of this segment will be fulfilled. To enter the run conditions, the cron
format is used. The default run condition is “always”.
• Edit Segment
On this screen you can generate the desired program for the selected segment. The
editor for the user program is started. It is described in “Program Editor” on
page 3-4.
S57901 User Manual
3-3