Download SLS User Guide

Contents
Disclaimer & Revisions
Operation of this equipment in a residential area is likely to cause interference, in which
case the user, at his or her own expense, will be required to take whatever measures
may be required to correct the interference.
Note: This equipment has been tested and found to comply with the limits for
Class A digital device pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with this User Guide, may clause interference to radio
communications. Operation of this equipment in a residential area is likely to
cause interference, in which case the user will be required to correct the
interference at his own expense.
The user is cautioned that changes and modifications made to the equipment
without approval of the manufacturer could void the user’s authority to operate
this equipment.
Changes or modifications to this device not explicitly approved by Lantronix will void the
user's authority to operate this device.
The information in this guide may change without notice. The manufacturer assumes no
responsibility for any errors that may appear in this guide.
Date
Rev. Comments
3/07
11/07
A
B
4/08
C
Initial Document
Changed baud rate default to 9600; added Detector utility for assigning
IP address; added ability to enable drive redirection, configure
backup/restore, and reset factory defaults; introduced a CLI and
commands.
Added Direct KVM; KVM-only mode; Spider network web page; ability
to preserve network settings for factory defaults; country code support;
iGoogle gadget; instructions for using the mounting kit.