Download MULTIPROTOCOL SOFTWARE USER'S MANUAL
Transcript
V-96 THE COMMAND INTERPRETER V.18. RINIT (19h): Reinitialize the card OPCODE = 25 (19h) DESCRIPTION This command resets the card's software. This command has the following format: OPCODE PARAMETER 1 DB7 0 0 DB6 0 0 DB5 0 0 DB4 1 0 DB3 1 0 DB2 0 0 DB1 0 0 DB0 1 Typ Typ: PARAMETER #1 DB0 If Typ = 1, all the card's variables and communication lines are reset to zero. The card is then waiting for the "RUN 02" start code. If Typ = 0, the card returns an error. WARNING Since the card does not return an end of command interrupt if Typ = 1, the programmer can determine if the card is ready to receive the RUN 02 start code by reading address 0 in the mailbox. Once the card is ready, it writes byte 0Fh at that address and the character string "MCX IS READY" at address 100 (64h). ERROR CODE If the command does not execute normally, code 154 (9Ah) is returned to indicate an error in the command. The cause of the error is: Error in parameter #1 MULTIPROTOCOL SOFTWARE USER’S MANUAL (DTUS016) - REV. B.03 JAN. 5, 1998