Download Model GP 3-E Installation Manual - AIS e-shop
Transcript
TYPICAL TUNING DIAGRAMS Model GP 3-E VHF Base Station Antenna 135-175 MHz NOTE: • It is recommended to use the curves as a guide and fine-tune using an SWR-Meter. B Copyright SIRIO antenne - Technical Data are subjected to change - Printed in ITALY - Rev. 01/07/1998 - Cod. ID059 Installation Manual DESCRIPTION 5/8 λ Ground Plane base station antenna for land and marine service. It works on the frequency range of 135-175 MHz by using the tuning diagram enclosed. The matching coil is DC feeded for a perfect protection from the static discharges. GP 3-E is made of non-corrosive aluminium and assembled on a very strong base of die-cast metal to get the maximun robustness and the best performance. Tuning is easy by following the attached directions. SPECIFICATIONS Electrical Data Type Frequency Range Impedance Radiation (H-plane) Radiation (E-plane) Radiation angle deg. Polarization Gain Bandwidth at V.S.W.R. 2:1 V.S.W.R. at res. freq. Max Power Feed System / Position Connection : : : : : : : : : : : : : 5/8 λ Ground Plane 135-175 MHz tunable by diagram 50 Ω Unbalanced 360o Omnidirectional Beamwidth at -3 dB = 67o 18o Vertical 1.5 dBd - 3.65 dBi 6.7 MHz at 135 MHz ≤ 1.2 : 1 200 Watts Transformer DC-Ground / Base UHF Female Mechanical Data Materials Wind Load / Resistance Wind Surface Heigth (approx.) Weight (approx.) Mounting Mast : : : : : : Aluminium, Nylon 28 N at 150 Km/h / 150 Km/h 0.02 m2 1480 mm 570 gr ∅ 25-30 mm ID059 MOUNTING INSTRUCTIONS