Download Monitor Rolling Stand Installation Manual
Transcript
ROLL STAND INSTALLATION GUIDE 1、 PARTS REFERENCE: (The following parts and hardware are included with this installation kit) ITEM MODEL DESCRIPTION NO. NO. QTY. 1 Roll Stand Base 1 2 Roll Stand Post 1 3 4 5 6 7 8 9 10 11 Swivel/Tilt Mounting Plate 1 Assembly Tray kit(Transition plate) 1 Accessories Basket 1 (includes mounting hardware) Sundries Basket 1 (includes mounting hardware) Hex Head Cap Screw (HHCS) (Fix baskets and the base) Screw (Fix the baskets and cable hook) Hex Head Cap Screw (HHCS) (Fix the mounting plate) Nylon Screw Hex Head Cap Screw (HHCS) (Fix the swivel part) M4X16 7 M4X8 12 M5X10 2 M4X12 2 M5X6 1 12 Hex Wrench 4# 1 13 Hex Wrench 5# 1 2、Assembling the Roll Stand 1) - Insert Roll Stand Post in Base and lay assembly on its side (not shown) for access to bottom of Base. - Using a M4X16 Hex Head Cap Screw (HHCS) to fix the post kit. AS SHOWN RIGHT 115-000080-00(VER A) PAGE 1, TOTAL 2 2) - Insert the tray kit to the top of the pole kit, use one M5X6 Hex Head Cap Screw (HHCS) to fix it with the post kit AS SHOWN RIGHT 3) - Use 2 pcs of M5X10 Hex Head Cap Screw (HHCS) to fix the mounting plate on the swivel/tilt part. - Tighten or loosen the socket head screw (Swivel Tension Screw) on the side of the Roll Stand Post , to adjust the tilt tension. AS SHOWN RIGHT 4) - Install the mounting kit onto the upper post with 4 pcs of M4X16 Hex Head Cap Screw (HHCS), and fix the accessories basket onto the mounting kit with 4 pcs of M4X8 screws provided. AS SHOWN RIGHT 5) - Fix the mounting kit (big) onto the lower post with 2 pcs of M4X16 Hex Head Cap Screw (HHCS). - Install the basket hook and the cable hook onto the mounting kit with 2 M4X8 screws provided. - plug the small sundries basket onto the basket hook. AS SHOWN RIGHT 115-000080-00(VER A) PAGE 2, TOTAL 2