Download GENERAL INSTALLATION MANUAL

Transcript
 2. ELECTRICAL INSTALLATION INSTRUCTION
Cable characteristics
Size: 4.0mm2
Type: TUV cable
Temperature rating of conductor: -40~120°C
Module configuration (Recommend)
# Maximum series configuration: please refer to Table 1 (This value is calculated under the condition of Voc at -40°C.)
# Maximum parallel strings without proper measures (e.g. fuse and/or blocking diode): 1 string.
(Note: Parallel configuration is not limited in case of taking proper measure (e.g. fuse for protection of module and
cable from over current, and/or blocking diode for prevention of unbalanced strings voltage) to block the reverse current
flow.)
3.
WARNING
Do not stand or step on the PV module (Glass, Frame, Film and Terminal box).
INSTALLATION MANUAL - PHOTOVOLTAIC MODULESELECTRICAL OUTPUT AND THERMAL CHARACTERISTIC
Rated electrical characteristics are within ±10 percent of the indicated values of Isc, Voc, and ±3 percent of
Pmax under STC (standard test conditions) (irradiance of 1000 W/m2, AM 1.5 spectrum, and a cell temperature
of 25 °C (77°F). The warranty conditions are specified elsewhere in this manual.
Model
Type
Table-1. Electrical characteristics (at STC)
Maximum Tolerance Open
Short
Power
Circuit circuit
(Pmax)
Voltage current
(Voc)
(Isc)
EGM-145
EGM-150
EGM-155
EGM-160
EGM-165
EGM-170
EGM-175
EGM-180
EGM-185
145W
150W
155W
160W
165W
170W
175W
180W
185W
±3%
±3%
±3%
±3%
±3%
±3%
±3%
±3%
±3%
43.52V
43.20V
41.56 V
43.68 V
43.74V
43.82 V
43.89 V
44.3V
44.38V
4.27A
4.95A
4.9 A
5.08 A
5.23 A
5.38 A
5.57 A
5.54A
5.7A
Maximum
Power
voltage
(Vmp)
Maximum Maximum Fuse
Application Maximum
Power
system
Current Class
Series
Current
Voltage
Configuration
(Imp)
36.26V
34.20V
33.58 V
35.54 V
34.47V
34.52 V
34.43 V
35.16V
35.16V
4.01A
4.39A
4.62 A
4.65 A
4.79 A
4.9 3 A
5.1 A
5.12A
5.27A
1000V
1000V
1000V
1000V
1000V
1000V
1000V
1000V
1000V
10A
10A
10 A
10A
10A
10 A
10 A
10 A
10 A
A
A
A
A
A
A
A
A
A
Under normal conditions, a photovoltaic module is likely to experience conditions that produce more current
and/or voltage than reported at Standard Test Conditions. Accordingly, the values of Isc and Voc marked on
this module should be multiplied by a factor of 1.25 when determining component voltage ratings, conductor
capacities, fuse sizes and size of controls connected to the module output.
9
52.71V
52.33V
50.34V
52.91V
52.98V
53.08V
53.16V
53.66V
53.76V