Download User manual M3
Transcript
2. Assembly 2. Assembly Please read the Safety advices on page 32 before installation and keep this user manual for future reference. 3,0 24,0 Se alin g 48 ,0 tion alla t s In Gap for physical dimension 1. 2. 3. ls ina rm e t m n 0m ctio 12 ne n o l. c inc h t p de After removing the fixing elements, insert the device. Check the seal to make sure it fits securely. Click the fixing elements back into place and tighten the clamping screws by hand. Then use a screwdriver to tighten them another half a turn. CAUTION! The torque should not exceed 0.1 Nm! Change signs of the physical unit before assembly via a channel at the side of the front! The change can only be done from the outside before assembly! 3