Download LASS user manual

4. OVERVIEW
LASS uses dimensions of the venue and listening areas (listening planes) based
on a section through the space to create a virtual model. The dimensions are
entered in the Listening Plane parameters window by pressing the
corresponding tab (bottom left, see left). The starting point is Xa and Ya, where
Xa is a horizontal coordinate typically representing the start of the listening plane
you want to cover, Xb, then, would be the end of that plane. Ya is the elevation of
the plane (if any) above the floor. Yb is used to set the floor’s rake – or height at
the back of the seating plane. Additional listener planes are then entered as
necessary, and balcony surfaces can also be entered as independent listener
planes. Listening planes can also be entered by clicking and dragging between
two points, and selecting the appropriate command from the pop-up menu. One
can also model areas outside of the main listening area if desired (such as the
stage), provided you remember to de-activate them prior to running the AutoOptimization sequence.
Listening
Planes
Next, the Parameters tab (bottom, second from left) provides a pull-down menu
for the Module selection (array element model), the height and position of the
array (X-Y coordinates correspond to the top frontal point of the upper element),
number of elements desired for the array, ear level, and “0-dB” reference
point (X ref-Y ref), among others. The 0-dB reference point (indicated by the
green “brain”) is the reference for SPL variation calculations (mapping is
performed in the Plots window), and typically represents the mix position or a
general reference point such as a point 2/3 of the way into the venue.
© SLS Loudspeakers, 2005
LASSMN-040105
3