Download User Manual

2015-07-07
User Manual SONO-VARIO Standard/Xtrem
6.
Installation of the Probe ............................................................................................................ 25
6.1. Further important Assembly Instructions.............................................................................. 26
6.2. Protection of the probe´s connector against splashing water .............................................. 28
6.3. Assembly Dimensions .......................................................................................................... 29
6.4. What to do if the Material Flow is not optimal? .................................................................... 31
6.5. Mounting in curved Surfaces ................................................................................................ 32
6.6. Gas- and waterproofed Installation in a Tube or Container ................................................. 32
6.7. Exchange of the Probe Head of the VARIOXtrem ............................................................... 33
6.7.1.
Basic Balancing of a new Probe Head.......................................................................... 34
7. Serial Connection to the SM-USB Module from IMKO ........................................................... 35
8. Quick Guide for the Commissioning Software SONO-CONFIG ............................................ 37
8.1.1.
Scan of connected SONO probes on the serial interface ............................................. 37
8.1.2.
Configuration of Measure Mode and serial SONO-interface ........................................ 38
8.1.3.
Set analogue outputs of the SONO probe .................................................................... 38
8.1.4.
Selection of the individual Calibration Curves .............................................................. 39
8.1.5.
“Test” run in the respective Measurement Mode .......................................................... 40
8.1.6.
“Measure” Run in Datalogging-Operation ..................................................................... 40
8.1.7.
Basic Balancing in Air and Water .................................................................................. 41
8.1.8.
Offsetting the material temperature sensor .................................................................. 42
8.1.9.
Compensation of the electronic temperature ............................................................... 42
9. Technical Data SONO-VARIO ................................................................................................... 43
Page 3