Download Installation and Operating Instructions

Mounting and installation
Connecting sensors to the terminal
4
An appropriate connector cable for each on-board computer which can be connected is available
from Müller-Elektronik. Our sales team will be glad to advise you.
You can find a list of on-board integrated display/controllers that we have tested here:
▪ Transfer target rates via LH5000 [➙ 53]
▪ Switching sections and transferring target rates via ASD [➙ 54]
For other on-board integrated display/controllers and for on-board integrated display/controllers with
other software versions, this function may not work at all or different from how it is described in these
instructions. Because the operating mode and configuration depends on the on-board integrated
display/controller, Müller-Elektronik can unfortunately not help you with their set-up. You must contact
the on-board integrated display/controller manufacturer for this.
On-board computer
Null modem cable
Adapter cable*
Available as a set with Cable 3, item number:
3032254800
Port B on the terminal
*When using an Amatron3 or Amatron+ as on-board integrated display/controller, you will only need a
traditional null modem cable. (Amatron3 and Amatron+ are on-board integrated display/controller
from Amazone)
4.8
Connecting sensors to the terminal
The terminal provides you with the possibility of connecting a sensor or the tractor's 7-pole signal
socket to port B. This allows you for example to use the working position signal in the TRACK-Leader
parallel guide.
The working position sensor that can be purchased from Müller Elektronik is fitted with a round 3-pin
plug. In order to connect this to the terminal, you will need an adapter cable.
Adaptor cable for the ME-sensor Y working position sensor
Adapter cable
Item number
3-pin to 9-pin
31302499
You can also connect the terminal to the signal socket.
30322538-02-EN
V2.20140724
21