Download User Guide - HEIGL GmbH
Transcript
Optidrive ODP-2 User Guide Revision 1.01 Optidrive P2 Easy Start Up Guide AC Supply Connection 3 Phase Units : Connect L1 L2 L3, PE 1 Phase Units : Connect L1, L2, PE Fuses or MCB Supply Voltage 200 – 240 Volts + / - 10% 380 – 380 Volts + / - 10% Fuses or MCB o Check the Drive Rating Information on page 37 Help Card Display Keypad Operation can be found on page16 Control Terminals Based on the factory default parameter settings Safe Torque Off (STO) Run – Stop 10K Speed Pot Link the terminals as shown, Close the switch to through the emergency stop run (enable), open circuit contacts to stop Motor Cable o For correct cable size, see Technical Data on page 37 o Observe the maximum permissible motor cable length o For Motor cable lengths > 50 metres, an output filter is recommended o Use a screened (shielded cable) M 2 Motor Connection Check for Star or Delta Connection Enter the Motor Nameplate Data into the drive Parameters as follows o Motor Rated Voltage : P1-07 o Motor Rated Current : P1-08 o Motor Rated Frequency : P1-09 o Motor Rated Speed (Optional) : P1-10 www.invertek.co.uk