Download IP-852 Channel User's Guide

Transcript
delays in packet processing if a packet is lost or corrupted. Whether enabled
or disabled, out-of-order packets are never sent onto the LONWORKS network.
Using SNTP When Creating IP-852 Channels
In small IP networks where there is no appreciable latency, it is not
necessary to specify an SNTP server for your IP-852 channel. However, when
creating IP-852 channels that span large IP networks where large network
delays may be present, you must specify an SNTP time server. This allows
each participant in the channel to synchronize to a common time base. Time
synchronization is required to implement some of the LONWORKS protocol’s
messaging services. For example, the LONWORKS protocol’s stale packet
detection algorithm requires a common time base to function properly.
You can specify SNTP servers at three levels: system, channel, and device.
Each device and channel may be configured to synchronize to its own SNTP
servers, or default to the next level up. For example, a device can default to
its channel SNTP servers, and a channel can default to its system SNTP
servers.
Specifying System SNTP Servers
To specify the system SNTP servers, follow these steps:
1. In the Configuration Server, select Settings from the Network menu and
click on the SNTP tab.
Figure 3.4 Setting the System SNTP Server
2. Enter the IP address or host name of the primary and secondary SNTP
servers. Note that the IP addresses must be static IP addresses. Leave
the default port numbers of 123.
28
IP-852 Channel User’s Guide