Download Operating instructions

1. Installation Micro-nozzle - as supplied
1.1 Installation Micro-nozzle
Install the nozzle body (2) with case
(3) and compact heater in the nozzle
absorption plate. First insert the heater
cables from above in the cut out of the
tool. Anti-rotation (5) must be located.
Bending cable outlet see
point 5, step 4.
1.2 Assembly as "Hot Half"
Note: Insert the O-rings (1) into the groove of the nozzle flange before assembly.
•The installation of the manifold can be made, after the height adjustment has already being made following
instructions according to PSG.
(See datasheet "Assembling instruction for standardized hot runner manifolds.")
•Centring pin and dowel pin must be installed.
Manifold
O-ring (1)
Dowel pin (manifold)
Anti-rotation dowel (nozzle)
Anti-rotation dowel (manifold)
Plate guidance
Mold plate
Ante-chamber sealing
Note: Plate guidance must work before immersing the nozzle into the ante-chamber sealing.
bedien_micro_2016_RX_A+H_Front_032014e - 2/8