Download Operating Instructions

84
Chapter 10
Functions
DEC
HEX
Function
Information on the function
83
53
Load CFG from project
Function MMC
90
5A
Activate firmware load mode (for 20 s)
Function MMC
91
5B
Load firmware
Function MMC
92
5C
Load HEX file from project
Function MMC
99
63
Reset firmware load mode
Function MMC
111
6F
Start automatic cooling adaptation
112
70
Start zone-wise automatic cooling adaptation
177
B1
Start current transfer all zones
200
C8
Switch on keylock
Operating and display unit function
201
C9
Switch off keylock
Operating and display unit function
440
1B8
Reset-acknowledge all alarms
441
1B9
Reset-acknowledge Alarm Output 1
442
1BA
Reset-acknowledge Alarm Output 2
443
1BB
Reset-acknowledge Alarm Output 3
501
1F5
Reset-acknowledge software reduction
502
1F6
Block group release
Group functions
600
258
Start diagnostic function for sensor allocation
Diagnostic function (code number 600)
- Allocation of Sensor and Heating
601
259
Start heating current diagnostics function
Diagnostic function (Code Number
601) - Start Current Measurement
602
25A
End diagnostic function and delete alarms
759
2F7
Establish ex-works state and controller reset
921
399
Profibus DPEA: Read in object list
922
39A
Profibus DPEA: Write object list into the EEPROM
985
3D9
Standard CPU matching
998
3E6
Delete EEPROM write errors
999
3E7
Reset control system
Rev. 1.00.10
Subject to technical changes without notice
For all zones, that should be adapted, set
bit 0x08 in control byte for zone by interface. Code number 112 activates the
cooling adaptation for the selected zones
and resets bit.