Download NuTone WS142AA Installation Guide

ALLURE™ WS1 SERIES
RANGE HOOD
Page 2
PREPARE HOOD LOCATION
PREPARE HOOD LOCATION
ROOF CAP
3¼" X 3¼”
10" x 10” or
(For7”
vertical
ROUND DUCT
discharge)
(For vertical discharge)
7” ROUND
VERTICAL DUCTING
SOFFIT
HOUSE WIRING
(Top or Back of hood)
CABINET
WALL CAP
HOOD
24" - 30" ABOVE
COOKING SURFACE
1
2
3¼" X 10" DUCT
(For horizontal discharge)
Determine whether hood will discharge vertically (3¼” x 10”
or 7” Round), horizontally (3¼” x 10” only) or non-ducted. For
vertical or horizontal discharge, run ductwork between the
hood location and a roof cap or wall cap. For best results, use
a minimum number of transitons and elbows.
Use diagrams, below, for proper placement of ductwork and
electrical cutout in cabinet or wall. For a non-ducted installation, DO NOT cut a duct access hole.
3
PREPARE THE HOOD
7” ROUND
DUCT PLATE
3¼” X 10”
VERTICAL DUCTING
HOOD MOUNTING SCREWS (4)
1315/16" (30" hood)
1315/16" (30" hood)
1615/16" (36" hood)
1615/16" (36" hood)
1915/16" (42" hood)
1915/16" (42" hood)
CABINET FRONT
7½"
CABINET BOTTOM
5¼"
5¼"
5"
1¼"
WOOD SHIMS
(recessed-bottom
cabinets only)
WOOD SHIMS
(recessed-bottom
cabinets only)
10½"
2"
VERTICAL DUCT
ACCESS HOLE
Run house wiring between service panel and hood location.
1½"
CENTER
LINE
ELECTRICAL
ACCESS HOLE
(in cabinet bottom)
1
3¼” X 10”
HORIZONTAL DUCTING
CABINET FRONT
1/8"
Remove 7” Round Duct Plate from top of hood. Set duct
plate aside - with mounting screws.
FILTERS
¾"
DUCT
3¾" HORIZONTAL
ACCESS HOLE
CABINET
5¼"
5¼"
BOTTOM
7½"
1315/16" (30" hood)
1315/16" (30" hood)
1615/16" (36" hood)
1615/16" (36" hood)
1915/16" (42" hood)
1915/16" (42" hood)
HOOD
ELECTRICAL
MOUNTING
CENTER
ACCESS HOLE
SCREWS (4)
LINE
(in wall)
2
Remove tape holding Filters in place. Pull down on filter
tabs and lift filters out. Set filters aside.